Type something to search...

CP Titanium (Grade 1-4) vs Titanium Alloys (Grade 5, 9, 23) — Complete Comparison

Commercially Pure (CP) Titanium Grades 1–4 are single-phase alpha metals whose strength (240–550 MPa) is controlled by interstitial oxygen content, whereas Titanium Alloys (Grades 5, 7, 9, 12, 23) add aluminum, vanadium, molybdenum, or palladium to achieve up to 1,000+ MPa strength or enhanced crevice corrosion limits.

Property CP Titanium (Grade 1-4) Titanium Alloys (Grade 5, 9, 23)
Microstructure Single-phase Alpha (α) Near-α, α+β, or Beta (β)
Tensile Strength Range (MPa) 240-550 (Gr1 to Gr4) 620-1150+ (Gr9, Gr5, Beta) ★
Elongation (%) 15-24+ ★ 10-15
Cold Formability Excellent (Gr1 deep-draw) ★ Good (Gr9) to Limited (Gr5)
Weldability Excellent across all CP grades ★ Good with inert gas shielding
Heat Treatability Stress-relief / anneal only Solution treat & age (STA) capable ★
Relative Mill Cost 1.0x Baseline ★ 1.4x to 2.2x

Choose CP Titanium (Grade 1-4) When

  • ✓ Chemical process tanks, columns, and piping
  • ✓ Desalination and power plant condensers
  • ✓ Deep drawing, spinning, or MMO anode substrates
  • ✓ Dental implants requiring unalloyed Grade 4

Choose Titanium Alloys (Grade 5, 9, 23) When

  • ✓ Aerospace airframes, discs, and fasteners
  • ✓ Orthopedic load-bearing implants (Grade 23 ELI)
  • ✓ High-pressure hydraulic tubing (Grade 9)
  • ✓ Hot brine >80°C crevice service (Grade 7 / Grade 12)

Engineering Trade-Off Analysis: CP Titanium (Grade 1-4) vs. Titanium Alloys (Grade 5, 9, 23)

How Oxygen Controls CP Grades 1 to 4: Grade 1 (O <= 0.18%) is the softest and most ductile grade for deep-drawn plate heat exchangers and clad explosion bonding; Grade 2 (O <= 0.25%) is the balanced industrial standard; Grade 3 (O <= 0.35%) and Grade 4 (O <= 0.40%, 550 MPa min tensile) provide higher strength in unalloyed form for dental implants and pressure vessels.

Alpha-Beta & Near-Alpha Alloy Capabilities: Adding alloying elements creates two-phase microstructures. Grade 9 (Ti-3Al-2.5V) bridges the gap between CP and Grade 5—offering 620+ MPa tensile strength with excellent cold-pilgering tube formability. Grade 5 and Grade 23 (Ti-6Al-4V) respond to solution treatment and aging (STA) and dominate high-stress structural engineering.

Selection Rule for Procurement Teams: Never over-specify an alpha-beta alloy if the component is governed by wall-thickness corrosion allowance or cold forming. Use CP Grade 1 or Grade 2 for process vessels, anodes, and heat exchangers; specify Grade 5, 9, or 23 when weight-specific yield strength or fatigue life governs the design.

Not sure which material is right for your project?

Our engineers can recommend the optimal grade based on your specific application, environment, and budget requirements.

Related Comparisons

Ready to Start Your Project?

Send your drawing or specification and we will reply within 24 hours.

Get a Quote
Quick Inquiry
WhatsApp