Type something to search...

Titanium (Grade 5) vs Inconel 625 — Complete Comparison

Titanium Grade 5 (Ti-6Al-4V) and Inconel 625 share comparable room-temperature tensile strength (~900 MPa), but Titanium weighs 47.5% less (4.43 g/cm³ vs. 8.44 g/cm³) and costs substantially less per unit volume, whereas Inconel 625 dominates extreme temperatures above 400°C.

Property Titanium (Grade 5) Inconel 625
Density (g/cm³) 4.43 ★ 8.44
Tensile Strength (MPa) 895-1000 827-1034
Max Service Temp (°C) 400 980 ★
Corrosion Resistance Excellent (seawater, oxidizing) Excellent (reducing + oxidizing) ★
Cost per kg (USD/kg) $22-38 ★ $80-150
Part Weight (Equal Volume) 47.5% lighter ★ Baseline (1.9x heavier)

Choose Titanium (Grade 5) When

  • ✓ Weight reduction is critical (subsea risers, aerospace)
  • ✓ Seawater, brine, and oxidizing chloride media
  • ✓ Operating temperature is below 400°C
  • ✓ Reducing per-part raw material cost vs. nickel alloys

Choose Inconel 625 When

  • ✓ Continuous operating temperature exceeds 400–980°C
  • ✓ Strong uninhibited reducing acids
  • ✓ Extreme thermal creep and oxidation service
  • ✓ Nuclear core or hot turbine exhaust components

Engineering Trade-Off Analysis: Titanium (Grade 5) vs. Inconel 625

Temperature Boundary (400°C Rule): Below 350–400°C, Titanium Grade 5 (and Grade 2/7/12 for chemical equipment) provides unmatched specific strength and chloride immunity at nearly half the weight of nickel superalloys. Above 450°C in air, titanium absorbs oxygen and nitrogen, so Inconel 625 or 718 must be used for hot gas turbines and exhaust manifolds.

Oxidizing Chlorides vs. Reducing Acids: In seawater, subsea risers, and wet chloride scrubbers, titanium matches or outperforms Inconel 625 at a fraction of the component weight. In concentrated reducing acids (such as hot uninhibited HCl or H2SO4), nickel-chromium-molybdenum alloys like Inconel 625 or Hastelloy C-276 are preferred.

Per-Part Volume Cost Advantage: Because Inconel 625 has nearly double the density of titanium (8.44 vs. 4.43 g/cm³), a machined titanium flange or subsea stress joint can need considerably less raw material by weight than the same part in Inconel 625.

Not sure which material is right for your project?

Our engineers can recommend the optimal grade based on your specific application, environment, and budget requirements.

Related Comparisons

Ready to Start Your Project?

Send your drawing or specification and we will reply within 24 hours.

Get a Quote
Quick Inquiry
WhatsApp